Oh No…

This is really bad. I think I somehow screwed up and never saved the artwork I drew for making the above drilling template. I think that I thought it was saved, made some other experimental (post-drilling) changes, then said not to save.

Uggh. This is really, really bad. Now I’m not completely sure where everything is drilled at, and because the drilling was without a jig, I can’t just measure to see.

Fortunately I still have my notes at home… I hope I can remember which number was which, and I can re-figure the hole spacing and such and re-draw it all.

Guh. I feel really, really bad about this.

I would have sworn that I saved it somewhere…

UPDATE: Found it! So I didn’t screw up as bad as I had thought. I had forgotten that I did a ‘Save As…’ with the file over to my G5 at one point. I must have kept working on that file, so I was saving my changes all along, just as I thought. It’s just that the file was being saved over to my G5 and not to this laptop. Thusly it didn’t show up in ‘Open Recent Files…’ or anywhere on this machine.

I SSH’d home, WOL’d the G5, SSH’d over there, FTP’d the files up to nuxx.net and poof. There they are. I feel amazingly relieved.