Press "Enter" to skip to content

Day: January 18, 2010

Kenda Small Block Eight

Published January 18, 2010

A rep from Kenda was set up at Ray’s MTB on Saturday displaying all manner of tires, tubes, and such. Conveniently all tires were also available for sale, at US$20/each, which is quite a bit below retail. I’ve been wanting to try out the Small Block Eight (SB8), a small knob smooth-rolling tire good for hard pack surfaces, so I picked up a pair of them in 29″ x 2.1″, the only 29er size made.

The Nevegals (which came stock on the bike, front and rear) don’t roll particularly smoothly but supposedly offer great control. Following some online recommendations I fitted the SB8 on the rear of the bike, leaving the nice, big knobs up front for better control. We’ll see how this shakes out once I actually start riding the bike, but at least I’ve now got a few options to play with. If nothing else I’m sure I can sell the Nevegals and SB8s for a reasonable price to fund some other tires.

Leave a Comment

Popcorn!

Published January 18, 2010

I am currently eating the popcorn pictured above, which was popped in in a pot on the stove, in a bit of veggie oil. It was then tossed with Penzy’s Brady Street Cheese Sprinkle and a bit of freshly ground chipotle. Yes, real chipotle, first cut up with scissors, then broken down in a blade mill, and finally finished in a mortar and pestle with a bit of salt.

I have also been strongly advised to substitute bacon grease for the veggie oil in the next batch. This seems like wise advise.

Leave a Comment

CrankBrothers Shoe Shields

Published January 18, 2010

After hearing about CrankBrothers Shoe Shields from my friend Erik I decided to give them a try. There is a fair bit of wear on my shoes (photo) from the Eggbeater pedals that I use and these thin metal plates should head this off and keep the shoes functional for even longer. Priced at $10.99/pair (at the local ACF) it wasn’t worth trying to make my own, as I don’t have a ready source of stainless steel nor an easy way to make similar cuts.

When the replacement pedals (Eggbeater SLs – photo) for my failed Eggbeater MXRs arrived today I decided that while fitting them to the bike I’d also replace the cleats and fit the Shoe Shields. While new pedals and cleats will normally feel a bit nicer, the addition of the Shoe Shields and their smoothing out the bottom of the shoe to better-than-new condition made clipping and unclipping during a test ride feel wonderful. While I imagine they’ll stand up to wear, it’ll be interesting to see just how long they last.

If you’d like to see more photos of them, including the packaging, install directions, thickness, and detail of the materials used, check out my CrankBrothers Shoe Shields album.

Leave a Comment