|
The box containing the parts for Ivan's P3, as picked up from FedEx Ground.
Date: 04/18/2008
Views: 39
|
Looking into the box after opening it showed it was very well packed, with double boxing for the enclosure itself.
Date: 04/18/2008
Views: 17
|
The three internal boxes.
Date: 04/18/2008
Views: 33
|
|
Most of the parts for Ivan's P3 laid out on a table next to my workbench for easy selection.
Date: 04/18/2008
Views: 51
|
The enclosure for Ivan's P3. Some of the PCBs, the display, and four of the front panel screws are fitted.
Date: 04/18/2008
Views: 27
|
Inside of the front panel, along with the key switches, keycaps, CPU, and pot PCBs. Note that this version does not use a subpanel for the pots.
Date: 04/18/2008
Views: 26
|
|
Detail of the area around the PLED, showing that the mounting holes do not align well with the mount points on the front panel.
Date: 04/18/2008
Views: 41
|
Looking inside the enclosure at the already fitted power switch, IO PCB, and main PCB, v1.5.
Date: 04/18/2008
Views: 20
|
The nice etched keycaps for the Sequentix P3. To me, these are one of the items which really add to the polish of the whole assembly.
Date: 04/18/2008
Views: 22
|
|
The pots for Ivan's P3, with lugs removed and washers fitted so they can be installed properly. Yes, there are a few spares here.
Date: 04/20/2008
Views: 41
|
The upper and lower pot boards for Ivan's Sequentix P3. Pots and all components are soldered into place, and they are ready to fasten into the enclosure.
Date: 04/20/2008
Views: 31
|
Top of the mainboard PCB, v1.5, for Ivan's P3. This is set up for MIDI sync only. All parts are fitted, but ICs have not yet been inserted in sockets.
Date: 04/20/2008
Views: 43
|
|
Bottom of the main PCB for Ivan's P3, setup for MIDI sync only.
Date: 04/20/2008
Views: 36
|
Detail of the 1K pullup resistor fitted on the bottom of the mainboard to work around issues with slow rise times on the MIDI due to the RFI filters.
Date: 04/20/2008
Views: 43
|
The rear of the completed IO board, showing the fitted RFI filters. Two are missing because this board is setup for MIDI sync.
Date: 04/20/2008
Views: 25
|
