Phase 1: Done

Click for more…

Ahh, phase one of the project to ‘properly’ connect an iPod to a 2006 Honda Civic is done. In short, I built this box and the cable running to the iPod. The box contains a filter to (hopefully) cut down on car engine noise and the break-out to provide the audio signal as two RCA connectors.

Inside of the shell of the iPod connector itself is a 1MΩ resistor which signals to the iPod that it has a car adapter connected so it should pause the iPod when power is disconnected, as this would typically happen when the car is shut off.

For now I’ll use this bundle of hardware to connect the iPod to the new car. It’ll power/charge the iPod, pause it when things are disconnected, and provide audio into the ‘aux in’ connector.

The next phase of the project is to wire the box (or perhaps just the iPod cable) into the car itself, either via factory-compatible connectors or straight hard wiring. My goal is to have the iPod powered from a keyed, filtered accessory line and the line-out to run straight into wherever the aux in connects to. I also want the iPod nicely mounted in a good location, within arm’s reach, and easy to navigate while driving. That kind of fitting (along with the factory-type connectors) I can’t do until I have the vehicle.

But, yeah. At least this much is done.