It Works

Click for more…

Well, the damn thing works. I got the connector wired properly, closed it up, and tested it with a 12v supply from the car. The iPod charges, and if it is playing and the power is disconnected, the iPod pauses. Tomorrow I’ll go get the stuffs to enclose the power filter and end-of-iPod-cable junction in a box. I’ll also stick a pair of RCA jacks on the outside of the box so that I can get audio out of it all.

I should have left the DIN5 on the far end of the cable for the time being so that it could have simply been plugged into the project box, but that’s okay.

The end result of this should be a temporary single cable iPod hookup which I can use until I get the car’s wiring figured out, connectors ordered, etc.

Earlier while working on this I became pretty frustrated with myself because after screwing up the first connector I made a second. Everything was going absolutely great until I realized that I’d wired it backwards, mixing up pins 1 and 30. And it was going so well, too. Ah well, at least it’s set for the time being. I’ve already got the RCA panel connectors, so I just need a project box. That shouldn’t be too hard to come across, I hope.

Now, I just wish I was tired. I thought the coffee I grabbed on the way home from ‘s place was a bad idea. It was. I’m nicely awake.

UPDATE: I forgot to mention what a pain it is to solder inside of these connectors. They are 0.6mm pins spaced 0.6mm apart. To make it a bit easier I took to removing unneeded pins from the last connector used, the one that was properly done.

See? Top · Bottom

An easier way to think of it is in regards to mechanical pencil lead. Most mechanical pencils that people use are either 0.5mm or 0.7mm. Most rollerball pens that people use make a 0.7mm wide line. That should give you an idea of what I was working with. Soldering one (or sometimes two wires) to something that small is a bit interesting.