Building on the Low-Cost Fat Bike Stand idea and needing a way to support the forthcoming Jones Plus build I’ve built a 29+ bike stand from PVC pipe. By taking the previous plans, narrowing the main section, and adding length and height I got something which securely holds a 29+ (700c x 3.0″) wheel.
Modifications to the original plan involve narrowing the center pieces by 1″, adding 0.5″ to each support leg, adding 1″ to the pieces between the upright and the back side, lengthening the horizontal pieces for an 11.75″ opening, and increasing the height of the upright for a 25.5″ opening. This results in a stand which allows the wheel to set in, touch the ground, and slightly lean sideways against one of the uprights. The stand can also be placed directly against a wall and approximately 1″ will be left between the tire and the wall.