 |
Today I received the voltage regulators to be used in the aforementioned power supply for the Bicycle Video Recorder that I’m working on. They fit perfectly in the PCB that I’d made, and worked exactly as expected. As the battery had a slight charge when received from All-Battery.com I was able to use it to test out the assembled power supply — as seen above — and I’m getting a proper 5V and 12V out of it. This is good.
Tomorrow I’ll give the battery a full charge, as I want to do the first charge in a relatively safe area, just in case something bad happens. I’m also hoping to finish up the routing and assembly of cables that will hold it all together. After this is done the setup should be ready to record video, and I should then be able to take it for a test ride and get on with battery life tests.
Figuring out where to run all the wires (out which sides of what) and how to bundle it all up in the bag will be a bit of a challenge. I’ve got an assortment of foam to use for padding things, but I’m not yet sure how I’ll arrange it all. The SanDisk V-Mate needs open access on the top during use, and the battery has to remain easily removable / unpluggable after use.
