 |
Today I did a bit more work on my new bike, applying UHMW polyethylene tape to various places where cables are observed rubbing the frame. Thus far it seems to have worked pretty well, although I have to place one or two more pieces to deal with cable rub on the fork. I also spent some time today wrapping the chainstay in an old scrubbed-clean tube tube to protect it from (and silence it during) chainslap. Photos of all of this can be seen under the following links:
· UHMW tape on the left front of the down tube to protect against cable rub.
· UHMW tape on the seat tube to (hopefully) keep the front derailleur housing from damaging the finish.
· A thin strip of UHMW tape on the Fox Float RP23 shock just in case the cable hits here.
· UHMW tape behind the computer wire-wrapped brake line on the fork crown.
· The drive side chainstay has been wrapped with part of an old tube to both protect it from damage and cut down on chainslap noise.
Now that the bike is almost complete (only waiting on a new saddle and stem) I’m becoming anxious to ride it. It’s too bad proper outdoor riding on it won’t happen until spring, when I can be reasonably sure that a bike won’t be stuffed with saltwater after riding around the block. Until then I’ll just keep riding my current bike.
(No, there are no complete photos of the new bike yet… I’m waiting until it’s wholly fitted out with the proper parts before this happens.)
Also, I scanned the piece of UHMW tape seen above along with its mate and the seat tube / rear derailleur cable piece before applying them so that I could reproduce them easily in the future if needed. These scans, at 1200dpi with false color to aid in cutting, can be found here:
Down Tube / Front Triangle Template · Seat Tube / Front Derailleur Housing Template.
