|
Head tube, bar, etc with Flak Jacket cable housings fitted. There is a bit more adjustment to be done.
Date: 12/24/2009
Views: 26
|
Made In USA sticker just above the bottom bracket on a Titus Racer X 29er.
Date: 12/24/2009
Views: 23
|
Rear shock area showing the cable routing. Some frame protectant will be applied beneath these cables.
Date: 12/24/2009
Views: 22
|
|
Cockpit area showing a New Holland Brewing cap on a Niner YAWYD, Nite Rider Rebel 1.0 computer, shifters, etc.
Date: 12/24/2009
Views: 29
|
Mounted Avid BB7 brake and 160mm rotor, SRAM PG-990 cassette, clean chain, etc.
Date: 12/24/2009
Views: 25
|
Fox fork, Nite Rider Rebel 1.0 wired sensor, BB7 brakes, and 185mm Clean Sweep G2 rotor.
Date: 12/24/2009
Views: 32
|
|
Contrary to what the manual implies, it is wholly possible to mount the Nite Rider bike computers (including the Rebel 1.0) with cable ties and not rubber O-rings. I added an extra cable tie for strain relief.
Date: 12/24/2009
Views: 63
|
Measuring my sit bones using a cheap piece of corrugated cardboard, spare aluminum plate, chair, and a ruler. I consistently measured ~122mm sit bone spacing.
Date: 12/26/2009
Views: 51
|
UHMW tape on the left front of the down tube to protect against cable rub.
Date: 12/28/2009
Views: 48
|
|
UHMW tape on the seat tube to (hopefully) keep the front derailleur housing from damaging the finish.
Date: 12/28/2009
Views: 40
|
A thin strip of UHMW tape on the Fox Float RP23 shock just in case the cable hits here.
Date: 12/28/2009
Views: 44
|
UHMW tape behind the computer wire-wrapped brake line on the fork crown.
Date: 12/28/2009
Views: 44
|
|
1200 dpi template for UHMW tape to protect the down tube (each side) on a Titus Racer X 29er, size Medium.
Date: 12/29/2009
Views: 25
|
1200 dpi template for UHMW tape to protect the seat tube (each side) from the rear derailleur housing on a Titus Racer X 29er, size Medium.
Date: 12/29/2009
Views: 26
|
The drive side chainstay has been wrapped with part of an old tube to both protect it from damage and cut down on chainslap noise.
Date: 12/28/2009
Views: 50
|
